Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Seat Heating Control Module Programming
To program and setup an existing or new replacement seat heating control module, perform the following procedure:
- Access the Service Programming System (SPS) and follow the onscreen instructions. Refer to Service Programming System (SPS) .
- On the SPS Supported Controllers screen, select HVSMF Front Seat Heating Control Module Programming and follow the onscreen instructions.
If the HVSMF Front Seat Heating Control Module fails to accept the program, verify all scan tool and seat heating control module connections are secure.
After programming is completed, perform the following to avoid future misdiagnosis:
- Turn the ignition OFF for 10 seconds.
- Open and close the door.
- Connect the scan tool to the data link connector.
- Ignition ON, engine OFF.
- Clear all DTCs from all modules.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.