Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2013 Chevrolet Trax LT, FWDSECTION Removal Procedure
- Remove the right instrument panel outer air outlet. Refer to Instrument Panel Outer Air Outlet Replacement (Buick) .
- Remove the right instrument panel outer trim cover. Refer to Instrument Panel Outer Trim Cover Replacement (Buick) .
- Remove the instrument panel upper compartment. Refer to Instrument Panel Upper Compartment Replacement (Buick) .
- Remove the instrument panel trim plate. Refer to Instrument Panel Trim Plate Replacement (Buick) .
- Remove the bolts (1) to loosen the instrument panel upper trim panel.
- Use a flat bladed plastic trim tool to aid in the removal of the right instrument panel retainer (1) from the instrument panel assembly.
- Disconnect the electrical connection.
- Carefully lift up the instrument panel upper trim panel enough to remove the instrument panel retainer (1).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.