Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2013TRAX LT, FWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINTERIOR/EXTERIOR TRIMINSTRUMENT PANEL TRIM AND CONSOLE TRIMREPAIR INSTRUCTIONSINSTRUMENT PANEL KNEE BOLSTER COMPARTMENT REPLACEMENT

2013 Chevrolet Trax LT, FWD

Instrument Panel Knee Bolster Compartment Replacement

2013 Chevrolet Trax LT, FWDSECTION Instrument Panel Knee Bolster Compartment Replacement

Fig 1: Instrument Panel Knee Bolster Compartment

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Instrument Panel Knee Bolster Compartment Procedures Squeeze the sides of the compartment door allowing the compartment to open past the stops. Release the bottom of the knee bolster compartment from the instrument panel assembly.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.