SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013TRAX LT, FWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINTERIOR/EXTERIOR TRIMINSTRUMENT PANEL TRIM AND CONSOLE TRIMREPAIR INSTRUCTIONSFRONT FLOOR CONSOLE REPLACEMENT (CHEVROLET)
2013 Chevrolet Trax LT, FWD

Front Floor Console Replacement (Chevrolet)

2013 Chevrolet Trax LT, FWDSECTION Front Floor Console Replacement (Chevrolet)
Fig 1: Front Floor Console
GM2854022Courtesy of GENERAL MOTORS COMPANY
Front Floor Console Replacement (Chevrolet)

Callout Component Name

Preliminary Procedures

  1. Remove both front floor console extension panels. Refer to Front Floor Console Extension Replacement - Left Side  and Front Floor Console Extension Replacement - Right Side .
  2. Remove the front floor console trim plate. Refer to Front Floor Console Trim Plate Replacement (Buick) .
1 Front Floor Console Fasteners (Qty: 8)
CAUTION:

Refer to Fastener Caution .

Procedures

  1. Position seats as necessary to access hole covers and fasteners.
  2. Use a flat bladed plastic trim tool to open the front floor console bolt access hole cover to access the fasteners from the rear of the floor console.
2 Front Floor Console

Procedures

  1. Disconnect electrical connections.
  2. Apply the parking brake.
  3. Place the transmission shift control rearward.
  4. With the aid of an assistant lift the floor console forward and over the park brake handle and away from the instrument panel assembly.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.