Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2013TRAX LS, AUTOMATIC TRANSREPAIR AND DIAGNOSISENGINE MECHANICALFUEL SYSTEMENGINE CONTROLS/FUEL - 1.8L (2H0) - REPAIR INSTRUCTIONSREPAIR INSTRUCTIONSTHROTTLE BODY ASSEMBLY REPLACEMENTREMOVAL PROCEDURE

2013 Chevrolet Trax LS, Automatic Trans

Removal Procedure

2013 Chevrolet Trax LS, Automatic TransSECTION Removal Procedure

Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement (2H0) .

Fig 1: Throttle Body Heater Outlet Pipe, Inlet Pipe And Positive Crankcase Ventilation Pipe

Courtesy of GENERAL MOTORS COMPANY

Disconnect the electrical wiring harness connector (2).
Disconnect the positive crankcase ventilation pipe (1).
Place collecting basin underneath.
Disconnect the throttle body heater outlet pipe (4).
Disconnect the throttle body heater inlet pipe (3).

Fig 2: Throttle Body

Courtesy of GENERAL MOTORS COMPANY

Remove the 4 throttle body bolts (2).
Remove the throttle body (1).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.