SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013TRAX LS, AUTOMATIC TRANSREPAIR AND DIAGNOSISENGINE MECHANICALFUEL SYSTEMENGINE CONTROLS/FUEL - 1.8L (2H0) - REPAIR INSTRUCTIONSREPAIR INSTRUCTIONSTHROTTLE BODY ASSEMBLY REPLACEMENTINSTALLATION PROCEDURE
2013 Chevrolet Trax LS, Automatic Trans

Installation Procedure

2013 Chevrolet Trax LS, Automatic TransSECTION Installation Procedure
    Fig 1: Throttle Body
    GM2026836Courtesy of GENERAL MOTORS COMPANY
  1. Install the throttle body (1).
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the 4 throttle body bolts (2) and tighten to 8 N.m (71 lb in).
    3. Fig 2: Throttle Body Heater Outlet Pipe, Inlet Pipe And Positive Crankcase Ventilation Pipe
    GM2027480Courtesy of GENERAL MOTORS COMPANY
  3. Connect the throttle body heater inlet pipe (3).
  4. Connect the throttle body heater outlet pipe (4).
  5. Connect the positive crankcase ventilation pipe (1).
  6. Connect the electrical wiring harness connector (2).
  7. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement (2H0) .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.