Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2013TRAX LS, AUTOMATIC TRANSREPAIR AND DIAGNOSISENGINE MECHANICALFUEL SYSTEMENGINE CONTROLS/FUEL - 1.8L (2H0) - REPAIR INSTRUCTIONSREPAIR INSTRUCTIONSIGNITION COIL REPLACEMENTINSTALLATION PROCEDURE

2013 Chevrolet Trax LS, Automatic Trans

Installation Procedure

2013 Chevrolet Trax LS, Automatic TransSECTION Installation Procedure

Fig 1: Ignition Coil Module And Remover/Installer

Courtesy of GENERAL MOTORS COMPANY

Install the EN-6009 remover/installer (1).
Install the ignition coil (2).
Remove the EN-6009 remover/installer (1).
Install the ignition coil fasteners an tighten to 8 (71 lb in).
NOTE:
Note the arrow on the cover.
Install the ignition coil cover in the opposite direction of the arrow.

Fig 2: Engine Wiring Trough And DIS-ignition Module Wiring Harness Plug

Courtesy of GENERAL MOTORS COMPANY

Connect the ignition coil electrical connector (2).
Install the engine wiring harness guide (1) at the cylinder head.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.