SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013TRAX LS, AUTOMATIC TRANSREPAIR AND DIAGNOSISENGINE MECHANICALFUEL SYSTEMENGINE CONTROLS/FUEL - 1.8L (2H0) - REPAIR INSTRUCTIONSREPAIR INSTRUCTIONSFUEL TANK REPLACEMENT (FWD)INSTALLATION PROCEDURE
2013 Chevrolet Trax LS, Automatic Trans

Installation Procedure

2013 Chevrolet Trax LS, Automatic TransSECTION Installation Procedure
  1. Transfer the fuel tank fuel pump module. Refer to Fuel Tank Fuel Pump Module Replacement (AWD)  and Fuel Tank Fuel Pump Module Replacement (FWD) .
  2. Transfer the evaporative emission canister. Refer to Evaporative Emission Canister Replacement (AWD)  or Evaporative Emission Canister Replacement (FWD) .
  3. Install the fuel tank to the hydraulic lift.
    4. Fig 1: Fuel Tank Strap
    GM2781362Courtesy of GENERAL MOTORS COMPANY
  4. With the aid of an assistant, position the fuel tank to the vehicle.
    5. CAUTION:

    Refer to Fastener Caution .

  5. Install both fuel tank straps to the fuel tank (2) and tighten the fasteners to 22 (16 lb ft).
  6. Remove the hydraulic lift from the fuel tank.
  7. Connect the EVAP system hoses. Refer to Evaporative Emission System Hose/Pipe Replacement (Fuel Pump Module to Vent Pipe AWD) , Evaporative Emission System Hose/Pipe Replacement (Fuel Pump Module to Canister AWD) , Evaporative Emission System Hose/Pipe Replacement (Canister to Pipe AWD) , Evaporative Emission System Hose/Pipe Replacement (Canister to Pipe FWD) , Evaporative Emission System Hose/Pipe Replacement (2H0) , Evaporative Emission System Hose/Pipe Replacement (Fuel Pump Module to Vent Pipe FWD)  or Evaporative Emission System Hose/Pipe Replacement (Fuel Pump Module to Canister FWD) .
  8. Connect the fuel feed pipe. Refer to Fuel Feed Pipe Replacement (At Tank AWD) , Fuel Feed Pipe Replacement (LDE)  or Fuel Feed Pipe Replacement (At Tank FWD) .
  9. Connect the fuel tank filler pipe. Refer to Fuel Tank Filler Pipe Replacement .
    10. Fig 2: Fuel Tank Fuel Pump Module Wiring Harness
    GM2781400Courtesy of GENERAL MOTORS COMPANY
  10. Connect the fuel tank fuel pump module wiring harness (1) and clip the fuel tank module wiring harness to the chassis.
  11. Install the exhaust. Refer to Exhaust Muffler Replacement (2H0, LUV) .
  12. Install the right rear wheelhouse panel liner. Refer to Rear Wheelhouse Liner Replacement .
  13. Lower the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.