Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013TRAX LS, AUTOMATIC TRANSREPAIR AND DIAGNOSISENGINE MECHANICALFUEL SYSTEMENGINE CONTROLS/FUEL - 1.8L (2H0) - REPAIR INSTRUCTIONSREPAIR INSTRUCTIONSACCELERATOR PEDAL POSITION SENSOR REPLACEMENT
2013 Chevrolet Trax LS, Automatic Trans
Accelerator Pedal Position Sensor Replacement
2013 Chevrolet Trax LS, Automatic TransSECTION Accelerator Pedal Position Sensor Replacement
Accelerator Pedal Position Sensor Replacement
| Callout | Component Name |
|---|---|
| 1 | Accelerator Pedal Position Sensor Fastener
CAUTION:
Refer to Fastener Caution . Tighten 10 N.m (89 lb in) |
| 2 | Accelerator Pedal Position Sensor Procedure Disconnect electrical connector. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.