SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013SILVERADO 2500 HD LT, 2D CAB CHASSIS, 6.6L ENG VIN 8, RWDREPAIR AND DIAGNOSISHEATING, VENTILATION & A/C (HVAC)HVAC CONTROL SYSTEMSHEATING, VENTILATION, AND AIR CONDITIONINGREPAIR INSTRUCTIONSBLOWER MOTOR CONTROL MODULE REPLACEMENT
2013 Chevrolet Silverado 2500 HD LT, 2D Cab Chassis, 6.6L Eng VIN 8, RWD

Blower Motor Control Module Replacement

2013 Chevrolet Silverado 2500 HD LT, 2D Cab Chassis, 6.6L Eng VIN 8, RWDSECTION Blower Motor Control Module Replacement
Fig 1: View Of Blower Motor Control Module & Screws
GM1696338Courtesy of GENERAL MOTORS COMPANY
Blower Motor Control Module Replacement

Callout Component Name

Preliminary Procedure

  1. Remove the I/P insulator panel. Refer to Instrument Panel Insulator Replacement (With RPO SLT) , Instrument Panel Insulator Replacement (Without RPO SLT) .
  2. Disconnect the blower motor control module electrical connector.
1 Blower Motor Control Module Screw (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
1.5 N.m (13 lb in)
2 Blower Motor Control Module
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.