Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013SILVERADO 2500 HD LT, 2D CAB CHASSIS, 6.6L ENG VIN 8, RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2552 (OBJECT DETECTION AND PEDESTRIAN PROTECTION SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC B1008: CALIBRATION DATA NOT PROGRAMMEDCIRCUIT/SYSTEM VERIFICATION
2013 Chevrolet Silverado 2500 HD LT, 2D Cab Chassis, 6.6L Eng VIN 8, RWD
Circuit/System Verification
2013 Chevrolet Silverado 2500 HD LT, 2D Cab Chassis, 6.6L Eng VIN 8, RWDSECTION Circuit/System Verification
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 GMC Sierra 3500 HD, 2015 GMC Sierra 2500 HD, 2015 GMC Sierra 1500, 2015 Chevrolet Silverado 3500 HD, and 2015 Chevrolet Silverado 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON.
- Verify that DTC B101E 42 is not set.
- If DTC is set
Perform the Front View Camera Module Programming and Setup procedure.
- If the DTC is not set
- If DTC is set
- Verify that DTC B1008 is not set.
- If DTC is set
- Calibrate the front camera module. Refer to Front View Camera Module Calibration .
- Verify the DTC does not set.
- If the DTC sets, replace the frontview camera module.
- If the DTC does not set
- All OK.
- If the DTC is not set
- All OK.
NOTE:
Do not diagnose this DTC if set in history
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.