Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013SILVERADO 2500 HD LT, 2D CAB CHASSIS, 6.6L ENG VIN 8, RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2318 (KEYLESS ENTRY SYSTEM AND REMOTE FUNCTIONS)
2013 Chevrolet Silverado 2500 HD LT, 2D Cab Chassis, 6.6L Eng VIN 8, RWD
Section 2318 (Keyless Entry System And Remote Functions)
2013 Chevrolet Silverado 2500 HD LT, 2D Cab Chassis, 6.6L Eng VIN 8, RWDSECTION Section 2318 (Keyless Entry System And Remote Functions)
WARNING: This page is about a different car, the 2012 GMC Sierra, 2012 GMC Cab & Chassis Sierra, 2012 Chevrolet Silverado, and 2012 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Wiring Schematics
- Diagnostic Information and Procedures
- Repair Instructions
- Description and Operation
- Garage Door Opener Description and Operation
- Keyless Entry System Description and Operation
- Notes
- Keyless Entry Transmitters
- Keyless Entry Antenna
- OnStar® Remote Link
- Remote Control Door Lock Receiver (RCDLR)
- Unlock Driver Door Only
- Unlock All Doors - Second Operation
- Lock All Doors
- Vehicle Locator/Panic Alarm
- Remote Vehicle Start (RVS) (if equipped)
- Enable/Disable RVS
- Hood Ajar Switch
- RVS Circuit Description
- Keyless Entry Personalization
- Special Tools and Equipment
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.