SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013SILVERADO 2500 HD LT, 2D CAB CHASSIS, 6.6L ENG VIN 8, RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2134 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - ELECTRONIC STEERING CONTROL MODULE X2 THROUGH MEMORY SEAT MODULE)COMPONENT CONNECTOR END VIEWSFOG LAMP- RIGHT FRONT (Z75)
2013 Chevrolet Silverado 2500 HD LT, 2D Cab Chassis, 6.6L Eng VIN 8, RWD

Fog Lamp- Right Front (Z75)

2013 Chevrolet Silverado 2500 HD LT, 2D Cab Chassis, 6.6L Eng VIN 8, RWDSECTION Fog Lamp- Right Front (Z75)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Fog Lamp- Right Front (Z75) Connector End View
GM684797Courtesy of GENERAL MOTORS CORP.
Fog Lamp- Right Front (Z75)

Pin Wire Circuit Function
A 0.8 PU 2234 Front Fog Lamp Control
B 0.8 BK 150 Ground
Connector Part Information
  • Harness Type: Right Front Fog Lamp
  • OEM Connector: 12059183
  • Service Connector: 12101898
  • Description: 2-Way F Metri-Pack 280 Series, Sealed (BK)
Terminal Part Information
  • Terminated Lead: Service by Connector Assembly- 12101898
  • Release Tool: J-38125-11A
  • Diagnostic Test Probe: J-35616-4A (PU)
  • Terminal/Tray: 12077411/2
  • Core/Insulation Crimp: 2/5
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.