SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013SILVERADO 2500 HD LT, 2D CAB CHASSIS, 6.6L ENG VIN 8, RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1114 (ANTI-LOCK BRAKE SYSTEM, TRACTION CONTROL SYSTEM & STABILITY CONTROL SYSTEM)REPAIR INSTRUCTIONSFRONT WHEEL SPEED SENSOR REPLACEMENT (AWD)REMOVAL PROCEDURE
2013 Chevrolet Silverado 2500 HD LT, 2D Cab Chassis, 6.6L Eng VIN 8, RWD

Removal Procedure

2013 Chevrolet Silverado 2500 HD LT, 2D Cab Chassis, 6.6L Eng VIN 8, RWDSECTION Removal Procedure
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to Brake Dust Caution .
    Fig 1: Wheel Speed Sensor Electrical Connector
    GM1969809Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Disconnect the wheel speed sensor electrical connector (1).
  4. Remove the wheel speed sensor wire harness clips (2) from the stabilizer bar bracket.
    5. Fig 2: View of Wheel Speed Sensor Wire Harness Clip
    GM1969812Courtesy of GENERAL MOTORS CORP.
  5. Remove the wheel speed sensor wire harness clip (1) from the steering knuckle.
    6. Fig 3: Wheel Speed Sensor Bolt
    GM1969815Courtesy of GENERAL MOTORS CORP.
  6. Thoroughly clean the wheel speed sensor mounting area of the steering knuckle of any dirt and debris.
  7. Remove the wheel speed sensor bolt (1).
    8. Fig 4: Wheel Speed Sensor
    GM1969821Courtesy of GENERAL MOTORS CORP.
  8. Remove the wheel speed sensor (1) from the steering knuckle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.