SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013SILVERADO 2500 HD LT, 2D CAB CHASSIS, 6.6L ENG VIN 8, RWDREPAIR AND DIAGNOSISENGINE PERFORMANCETUNE-UPENGINE CONTROLS/FUEL - 6.6L (LGH OR LML) - REPAIR INSTRUCTIONSREPAIR INSTRUCTIONSGLOW PLUG CONTROL MODULE REPLACEMENT
2013 Chevrolet Silverado 2500 HD LT, 2D Cab Chassis, 6.6L Eng VIN 8, RWD

Glow Plug Control Module Replacement

2013 Chevrolet Silverado 2500 HD LT, 2D Cab Chassis, 6.6L Eng VIN 8, RWDSECTION Glow Plug Control Module Replacement
Fig 1: Identifying Glow Plug Control Module And Fasteners
GM2406346Courtesy of GENERAL MOTORS COMPANY
Glow Plug Control Module Replacement

Callout Component Name
1 Glow Plug Module Fastener (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
10 N.m (89 lb in)
2 Glow Plug Module

Procedure

  1. Disconnect the electrical connectors.
  2. If the scan tool DPF Soot Mass is less than 30 grams, enable the DPF. Refer to Diesel Particulate Filter (DPF) Regeneration Enable .
  3. If the scan tool DPF Soot Mass is 30 grams or greater, refer to Diesel Particulate Filter (DPF) Service Regeneration .
  4. Perform the glow plug module programming and setup. Refer to Glow Plug Control Module Programming and Setup
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.