Garage Door Opener Transmitter Replacement

2013 Chevrolet Silverado 2500 HD LT, 2D Cab Chassis, 6.6L Eng VIN 8, RWDSECTION Garage Door Opener Transmitter Replacement
Fig 1: View Of Garage Door Opener Transmitter Assembly & Screws
GM1709050Courtesy of GENERAL MOTORS COMPANY
Garage Door Opener Transmitter Replacement

Callout Component Name
Preliminary Procedure 
Lower the overhead console enough to access the garage door opener. Refer to Roof Console Replacement .
1 Garage Door Opener Transmitter Screws (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
2 N.m (18 lb in)
2 Garage Door Opener Transmitter Assembly

Procedure

  1. Disconnect the electrical connection.
  2. Refer to Control Module References for programming and set up procedures.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.