Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013SILVERADO 2500 HD LT, 2D CAB CHASSIS, 6.6L ENG VIN 8, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSWIRING DIAGRAMSWIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - FUEL PUMP/TRAILER BRAKE CONTROL MODULE TO RADIO X1 (UYS)COMPONENT CONNECTOR END VIEWSINFRARED TRANSMITTER (U42)
2013 Chevrolet Silverado 2500 HD LT, 2D Cab Chassis, 6.6L Eng VIN 8, RWD
Infrared Transmitter (U42)
2013 Chevrolet Silverado 2500 HD LT, 2D Cab Chassis, 6.6L Eng VIN 8, RWDSECTION Infrared Transmitter (U42)
Connector Part Information
|
Terminal Part Information
|
Infrared Transmitter (U42)
| Pin | Wire | Circuit | Function |
|---|---|---|---|
| 1 | 0.35 L-BU | 5826 | Left DVD Audio Signal (+) |
| 2 | 0.35 PU | 6979 | DVD Audio Common |
| 3 | 0.35 WH | 5828 | Right DVD Audio Signal (+) |
| 4 | 0.35 PK | 5829 | Infra Red Module Supply Voltage (UK6) |
| 5-7 | - | - | Not Used |
| 8 | 0.35 OG/BK | 5831 | Remote Infra Red Signal (+) |
| 9 | 0.35 OG/BK | 5329 | Left Infra Red Audio Signal (UK6) |
| 10 | 0.35 BN/WH | 5331 | Infra Red Audio Low Reference (UK6) |
| 11 | 0.35 PU/WH | 5330 | Right Infra Red Audio Signal (UK6) |
| 12 | 0.35 BK | 2550 | Ground (UK6) |
| 13-15 | - | - | Not Used |
| 16 | 0.35 TN/WH | 5830 | Remote Infra Red Signal (-) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.