SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013SILVERADO 2500 HD LT, 2D CAB CHASSIS, 6.6L ENG VIN 8, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSWIRING DIAGRAMSWIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - DRIVE MOTOR GENERATOR BATTERY CONTROL MODULE TO FUEL PUMP DISABLE MODULECOMPONENT CONNECTOR END VIEWSELECTRONIC ADJUSTABLE PEDAL (EAP) ASSEMBLY (JF4)
2013 Chevrolet Silverado 2500 HD LT, 2D Cab Chassis, 6.6L Eng VIN 8, RWD

Electronic Adjustable Pedal (EAP) Assembly (JF4)

2013 Chevrolet Silverado 2500 HD LT, 2D Cab Chassis, 6.6L Eng VIN 8, RWDSECTION Electronic Adjustable Pedal (EAP) Assembly (JF4)
GM1711022Courtesy of GENERAL MOTORS COMPANY
Connector Part Information
  • Harness Type: Pedal Jumper
  • OEM Connector: 15477860
  • Service Connector: 13574938
  • Description: 6-Way F BFC 180 Series (BK)
Terminal Part Information
  • Pins: 1-3
  • Terminal/Tray: 173630-7/7
  • Core/Insulation Crimp: E/4
  • Release Tool/Test Probe: 15315247/J-35616-33 (YE)
  • Pins: 4-5
  • Terminal/Tray: 173630-7/7
  • Core/Insulation Crimp: E/A
  • Release Tool/Test Probe: 15315247/J-35616-33 (YE)
Electronic Adjustable Pedal (EAP) Assembly (JF4)

Pin Wire Circuit Function
1 0.5 TN 6207 5-Volt Reference (AN3)
2 0.5 PK 5289 Adjustable Pedal Sensor Signal (AN3)
3 0.5 GY 6206 Low Reference (AN3)
4 1 YE 5129 Adjustable Pedals Relay Rearward Control
5 1 PU 5130 Adjustable Pedals Relay Forward Control
6 - - Not Used
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.