SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013SILVERADO 2500 HD LT, 2D CAB CHASSIS, 6.6L ENG VIN 8, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSWIRING DIAGRAMSWIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - 1-2 SHIFT SOLENOID TO DRIVE MOTOR GENERATOR BATTERY MODULE (X3)COMPONENT CONNECTOR END VIEWSBODY CONTROL MODULE (BCM) X5
2013 Chevrolet Silverado 2500 HD LT, 2D Cab Chassis, 6.6L Eng VIN 8, RWD

Body Control Module (BCM) X5

2013 Chevrolet Silverado 2500 HD LT, 2D Cab Chassis, 6.6L Eng VIN 8, RWDSECTION Body Control Module (BCM) X5
GM1664500
Connector Part Information
  • Harness Type: Instrument Panel
  • OEM Connector: 15480179
  • Service Connector: 88988837
  • Description: 25-Way F HIT Series (BN)
Terminal Part Information
  • Pins: 1, 2, 4, 5
  • Terminated Lead: 13327199
  • Release Tool: J-38125-12A
  • Diagnostic Test Probe: J-35616-35 (VT)
  • Terminal/Tray: SNAC-A061T-M2.8/20
  • Core/Insulation Crimp: Pin: 1, 2 -C/A
  • Core/Insulation Crimp: Pins: 4, 5 - E/A
  • Pins: 6, 7-11, 13-16, 18-21, 23-24
  • Terminated Lead: 13575870
  • Release Tool: J-38125-12A
  • Diagnostic Test Probe: J-35616-64B (L-BU)
  • Terminal/Tray: SNAC3-A021T-M0.64/20
  • Core/Insulation Crimp: J/J
Body Control Module (BCM) X5

Pin Wire Circuit Function
1 1 YE 18 Left Rear Stop/Turn Lamp Supply Voltage
2 1 D-GN 19 Right Rear Stop/Turn Lamp Supply Voltage
3 - - Not Used
4 0.5 L-BU/WH 1314 Left Front Turn Signal Lamp Supply Voltage
5 0.5 L-BU 1320 CHMSL Supply Voltage/Stop Lamp Supply Voltage
6 0.35 L-BU/WH 6311 Cruise/ETC/TCC Brake Signal
7 - - Not Used
8 0.5 PK 5076 Current Sensor Supply Voltage (10 Series except MEX)
9 0.5 WH 5075 Current Sensor Signal (10 Series except MEX)
10 0.5 BN 5077 Low Reference (10 Series except MEX)
11 0.35 D-BU 38 Backup Lamp Relay Control
12 - - Not Used
13 0.35 OG 300 Ignition 3 Voltage
14 0.35 WH 2283 12-Volt Reference (NQF, NQH or 10 Series except MEX or except 8S8)
15 0.35 PU 5531 Hood Closed Switch Signal (AP3 or AP8)
16 0.35 L-BU 1134 Park Brake Switch Signal (Park brake systems only)
17 - - Not Used
18 0.35 TN 28 Horn Relay Control (except MEX)
19 0.35 YE 6812 Out of Park Signal (YE9 or HP2)
20 0.35 GY 91 Windshield Wiper Switch Signal 2
21 0.35 TN 860 Front Windshield Wiper Switch High Signal Control
22 - - Not Used
23 0.35 PK/WH 1970 Headlamp Low Beam Relay Control
24 0.35 D-BU 45 Park Lamp Relay Control
25 - - Not Used
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.