Automatic Transmission Auxiliary Fluid Pump Control Module X2 (HP2)

2013 Chevrolet Silverado 2500 HD LT, 2D Cab Chassis, 6.6L Eng VIN 8, RWDSECTION Automatic Transmission Auxiliary Fluid Pump Control Module X2 (HP2)
GM2217343
Connector Part Information
  • Harness Type: Automatic Transmission Auxiliary Fluid Pump
  • OEM Connector: 7283-5595-10
  • Service Connector: 19153180
  • Description: 4-Way F 250 Series, Sealed (D-GY)
Terminal Part Information
  • Terminated Lead: Service by Assembly- See Part Catalog
  • Release Tool: Pending
  • Diagnostic Test Probe: Pending
  • Terminal/Tray: Not Available
  • Core/Insulation Crimp: Not Available
Automatic Transmission Auxiliary Fluid Pump Control Module X2 (HP2)

Pin Wire Circuit Function
1 5 RD 922 AC Voltage Phase A
2 5 D-BU 933 AC Voltage Phase B
3 5 YE 944 AC Voltage Phase C
4 0.8 BARE 955 Drain Wire
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.