Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013SILVERADO 2500 HD LT, 2D CAB CHASSIS, 6.6L ENG VIN 8, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTENTERTAINMENT SYSTEMSCELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESDTC B2470CIRCUIT/SYSTEM TESTING
2013 Chevrolet Silverado 2500 HD LT, 2D Cab Chassis, 6.6L Eng VIN 8, RWD
Circuit/System Testing
2013 Chevrolet Silverado 2500 HD LT, 2D Cab Chassis, 6.6L Eng VIN 8, RWDSECTION Circuit/System Testing
NOTE:
The vehicle may be equipped with sectioned coax. Test each section and replace only the faulty section, not the entire length of coax.
- Ignition OFF, disconnect the GPS and cellular coax cable connector at the VCIM.
- Using the EL-49903-3 kit (EL-49903-5 adapter and EL-49903-4 coax cable), connect the EL-49903 GM OnStar antenna diagnostic tool kit to the VCIM.
- Clear the DTCs and operate the vehicle within the conditions for running the DTC. Verify DTC B2470 does not set.
- If the DTC sets, replace the VCIM.
- Ignition OFF, disconnect the EL-49903
GM OnStar antenna diagnostic tool kit from the VCIM and perform the coax cable test on the coax cable between the VCIM and the cellular and navigation antenna.
- If the coax cable does not pass the test, replace the coax cable.
- If all circuits test normal, replace the cellular and navigation antenna.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.