SYS.OK|MANUAL.DB● LIVE
2013 Chevrolet Silverado 1500 LS, 4D Pickup, RWD

Quick Lookups: Fluids

2013 Chevrolet Silverado 1500 LS, 4D Pickup, RWDSECTION Fluids
FLUID CAPACITIES
Fluid Type Application Standard Metric Fluid Spec Note S/H
Air Cond Compressor Oil Gas/Ethanol w/o Rear AC 7.10 OZS. 0.2 L PAG 46 S
Air Cond Compressor Oil Gas/Ethanol w/Rear A/C 11.00 OZS. 0.32 L PAG 46 S
Air Cond Refrigerant Front & Rear 2.50 LBS. 1.13 KG R-134a S
Air Cond Refrigerant Front 1.60 LBS. 0.72 KG R-134a S
Automatic Transmission Fluid Trans Mfr CD 4L60E/M30 Drain and Refill 5.00 QTS. 4.73 L Automatic Transmission Fluid DEXRON VI All capacities are approximate. When adding, be sure to fill to the approximate level. Recheck the fluid level after filling. S
Automatic Transmission Fluid Trans Mfr CD 4L60E/M30 Dry,300 mm Torque Converter 11.20 QTS. 10.59 L Automatic Transmission Fluid DEXRON VI All capacities are approximate. When adding, be sure to fill to the approximate level. Recheck the fluid level after filling. S
Automatic Transmission Fluid Trans Mfr CD 4L60E/M30 Overhaul 11.00 QTS. 10.4 L Automatic Transmission Fluid DEXRON VI All capacities are approximate. When adding, be sure to fill to the approximate level. Recheck the fluid level after filling. S
Brake Fluid N/A N/A DOT 3 Hydraulic Brake Fluid S
Diesel Exhaust Fluid 5.30 GALS. 20.06 L Diesel Exhaust Fluid Approximate capacity. Diesel Exhaust Fluid or diesel exhaust fluid that meets ISO 22241-1 or displays the API Diesel Exhaust Fluid Certification Mark. S
Differential Gear Oil Front Axle 8.25" 1.51 QTS. 1.42 L Front Axle (1500 Series 4WD): SAE 80W-90 Gear Oil. Front Axle (1500, 2500 HD, and 3500 HD Series): SAE 75W-90 Synthetic Gear Oil. S
Differential Gear Oil Rear Axle 8.6",w/o RPO AXN 2.15 QTS. 2.03 L SAE 75W-90 Synthetic Gear Oil S
Differential Gear Oil Rear Axle 9.5" LD,w/RPO AXN 2.75 QTS. 2.6 L SAE 75W-90 Synthetic Gear Oil S
Engine Coolant 2 Mode Hybrid Drive Motor Generator Control Module 2.90 QTS. 2.74 L 50/50 mixture of DEX-COOL and clean, drinkable water All capacities are approximate. When adding, be sure to fill to the approximate level. Recheck the fluid level after filling. S
Engine Coolant 4.8L Eng 16.90 QTS. 15.99 L 50/50 mixture of DEX-COOL and clean, drinkable water All capacities are approximate. When adding, be sure to fill to the approximate level. Recheck the fluid level after filling. S
Engine Oil 4.8L Eng w/Filter 6.00 QTS. 5.67 L API - SAE 5W-30 Use only engine oil licensed to the dexos1 specification, or equivalent. ACDelco dexos1 Synthetic Blend is recommended. Failure to use the recommended engine oil or equivalent can result in engine damage not covered by the vehicle warranty. Check to be sure the oil is approved to the dexos1 specification. For areas of extreme cold, where temperatures fall below -20Deg.F (-29Deg.C), it is recommended a SAE 5W-30 synthetic oil or a SAE 10W-30 oil. Both will provide easier cold starting and better protection for your engine at extremely low temperatures. DO NOT use other viscosity grade oils such as SAE 10W-30, 10W-40, or 10W-50. S
Fuel Tank Pickup 26.00 GALS. 98.42 L S
Transfer Case Fluid 1.60 QTS. 1.51 L Automatic Transmission Fluid DEXRON VI All capacities are approximate. When adding, be sure to fill to the approximate level. Recheck the fluid level after filling. S
Windshield Washer Fluid N/A N/A Windshield Washer Fluid Follow the Manufacturer's Instructions for the mixture ratio. Automotive windshield washer fluid that meets regional freeze protection requirements. S
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.