Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2013SILVERADO 1500 LS, 4D PICKUP, RWDREPAIR AND DIAGNOSISHEATING, VENTILATION & A/C (HVAC)HVAC CONTROL SYSTEMSHEATING, VENTILATION, AND AIR CONDITIONINGREPAIR INSTRUCTIONSAIR CONDITIONING COMPRESSOR BRACKET REPLACEMENT (HP2)

2013 Chevrolet Silverado 1500 LS, 4D Pickup, RWD

Air Conditioning Compressor Bracket Replacement (HP2)

2013 Chevrolet Silverado 1500 LS, 4D Pickup, RWDSECTION Air Conditioning Compressor Bracket Replacement (HP2)

Fig 1: Compressor Mounting Bracket (HP2)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the air conditioning compressor. Refer to Air Conditioning Compressor Replacement (LZ1, L20, LC9, L9H, L92, LMG) . Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the engine shield. Refer to Engine Shield Replacement . Remove the oil pan slid plate. Remove transmission cooler bracket.
1	A/C Compressor Bracket Bolt CAUTION: Refer to Fastener Caution . Tighten 50 N.m (37 lb ft)
2	A/C Compressor Bracket Bolt (Qty: 2) Tighten 50 N.m (37 lb ft)
3	A/C Compressor Bracket Bolt (Qty: 3) Tighten 50 N.m (37 lb ft)
4	A/C Compressor Bracket

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.