Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013SILVERADO 1500 4WD V8-5.3LREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINDIFFERENTIAL ASSEMBLYSERVICE AND REPAIRREMOVAL AND REPLACEMENTFRONT DRIVE AXLEVENT HOSE REPLACEMENT (9.25 INCH AXLE)
2013 Chevrolet Silverado 1500 4WD V8-5.3L
Vent Hose Replacement (9.25 Inch Axle)
2013 Chevrolet Silverado 1500 4WD V8-5.3LSECTION Vent Hose Replacement (9.25 Inch Axle)
Vent Hose Replacement (9.25 Inch Axle)
Removal Procedure
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.
2. Remove the engine shield, if equipped. Refer to Engine Shield Replacement .
Important:
Make note of the routing in order to aid in reassembly.
3. Remove the vent hose (1) from the wiring bundle (2), S4WD axles only.
4. Remove the vent hose from the retainer clips, all axles.
5. Remove the vent hose from the differential carrier assembly.
6. Remove the vent hose from the vehicle.
Installation Procedure
1. Install the vent hose to the vehicle.
* Route the vent hose the same way as when removed.
* Ensure the hose is free of kinks and routes clear of sharp components.
* Ensure the vent hose is not plugged.
2. Connect the vent hose to the differential carrier assembly.
3. Install the vent hose (1) to the wiring bundle (2), S4WD axles only.
4. Install the vent hose to the retainer clips, all axles.
5. Install the engine shield, if equipped. Refer to Engine Shield Replacement .
6. Lower the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.