Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2013 Chevrolet Impala LTZSECTION Installation Procedure
- Install the fuel pump flow control module (2).
- Install the fuel pump flow control module bolts (1) and tighten to 6.5 N.m (58 lb in).
- Install the fuel pump flow control module and bracket (2).
- Install the fuel pump flow control module bracket nuts (1) and tighten to 5 N.m (44 lb in).
- Connect the electrical connector.
- Install the rear compartment side trim panel right side. Refer to Rear Compartment Side Trim Replacement - Right Side
- If replacing, reprogram the module. Refer to Control Module References
CAUTION:
Refer to Fastener Caution .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.