Fastener Tightening Specifications

2013 Chevrolet Impala LTZSECTION Fastener Tightening Specifications
Fastener Tightening Specifications

Application Specification
Metric  English 
Battery Hold Down Fastener 18 N.m 13 lb ft
Battery Tray Fastener 5 N.m 44 lb in
Engine Harness Ground Terminal -to- Battery Negative Engine Ground Stud Fastener 20 N.m 15 lb ft
Generator Mounting Fasteners 58 N.m 43 lb ft
Generator Output BAT + Terminal Fastener 20 N.m 15 lb ft
Negative Battery Cable Engine Block Ground Stud/Fastener 50 N.m 37 lb ft
Negative Battery Cable Upper Tie Bar Ground Fastener 10 N.m 89 lb in
Positive Battery Cable Underhood Fuse Block Terminal Fastener 15 N.m 11 lb ft
Starter Heat Shield Fastener 5 N.m 44 lb in
Starter Mounting Fastener 58 N.m 43 lb ft
Starter Solenoid "BAT" Terminal Nut 10 N.m 89 lb in
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.