Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013EQUINOX LS, AWD, GASREPAIR AND DIAGNOSISELECTRICALWIRING DIAGRAMSWIRING SYSTEMS AND POWER MANAGEMENT SYSTEM - COMPONENT CONNECTOR END VIEWS - K9 THROUGH K43 (LEA)COMPONENT CONNECTOR END VIEWSK39 LIFTGATE CONTROL MODULE X3 (TB5)
2013 Chevrolet Equinox LS, AWD, Gas
K39 Liftgate Control Module X3 (TB5)
2013 Chevrolet Equinox LS, AWD, GasSECTION K39 Liftgate Control Module X3 (TB5)
Connector Part Information
|
Terminal Part Information
| Terminal Type ID | Terminated Lead | Diagnostic Test Probe | Terminal Removal Tool | Service Terminal | Tray | Core Crimp | Insulation Crimp |
|---|---|---|---|---|---|---|---|
| I | 13575832 | J-35616-35 (VT) | J-38125-11A | 7116-4112-02 | 9 | C | D |
| II | 13578896 | J-35616-64B (L-BU) | J-38125-553 | 7116-4720-02 | 14 | J | J |
K39 Liftgate Control Module X3 (TB5)
| Pin | Size | Color | Circuit | Function | Terminal Type ID | Option |
|---|---|---|---|---|---|---|
| 1 | 3 | WH | 5798 | Liftgate Motor Open Control | I | - |
| 2 | 3 | BN/WH | 5799 | Liftgate Motor Close Control | I | - |
| 3-5 | - | - | - | Not Occupied | - | - |
| 6 | 0.5 | BARE | 701 | Ground Distribution Drain Wire | II | - |
| 7-14 | - | - | - | Not Occupied | - | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.