SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013EQUINOX LS, AWD, GASREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTCELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEMREPAIR INSTRUCTIONSRADIO CONTROL ASSEMBLY REPLACEMENT
2013 Chevrolet Equinox LS, AWD, Gas

Radio Control Assembly Replacement

2013 Chevrolet Equinox LS, AWD, GasSECTION Radio Control Assembly Replacement
Fig 1: Radio Control Assembly (1)
GM2244752Courtesy of GENERAL MOTORS COMPANY
Radio Control Assembly Replacement

Callout Component Name
Preliminary Procedure 
For vehicles equipped with the instrument panel center trim plate. Refer to Instrument Panel Upper Center Trim Panel Replacement (Terrain) , Instrument Panel Upper Center Trim Panel Replacement (Equinox) , for removal. For vehicles equipped with the instrument panel center compartment. Refer to Instrument Panel Center Compartment Replacement (Equinox) , Instrument Panel Center Compartment Replacement (Terrain) for removal.
1 Radio Control Assembly

Procedure

  1. Use a flat-bladed plastic trim tool in order to release the retainer clips securing the AM/FM stereo and clock and audio disc player radio control assembly to the instrument panel.
  2. Disconnect the electrical connections.
  3. When replacing the radio control assembly, transfer all necessary components.
  4. Refer to Control Module References for programming and setup information.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.