SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013EQUINOX LS, AWD, GASREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTCELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEMREPAIR INSTRUCTIONSRADIO ANTENNA CABLE EXTENSION CABLE REPLACEMENT
2013 Chevrolet Equinox LS, AWD, Gas

Radio Antenna Cable Extension Cable Replacement

2013 Chevrolet Equinox LS, AWD, GasSECTION Radio Antenna Cable Extension Cable Replacement
Fig 1: Radio Antenna Cable Extension Cable
GM2252601Courtesy of GENERAL MOTORS COMPANY
Radio Antenna Cable Extension Cable Replacement

Callout Component Name
Preliminary Procedure 
Lower the headlining trim panel where needed. Refer to Headlining Trim Panel Replacement .
1 Radio Antenna Cable Extension Cable

Procedure

  1. Disconnect the electrical connectors at each end of the antenna.
  2. If the antenna cable is taped into the wiring harness then cut the ends off the old antenna and route the new antenna as close to the old one as possible using tie straps to secure the new cable.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.