Digital Video Antenna Cable Replacement

2013 Chevrolet Equinox LS, AWD, GasSECTION Digital Video Antenna Cable Replacement
Fig 1: Digital Video Antenna Cable
GM2351839Courtesy of GENERAL MOTORS COMPANY
Digital Video Antenna Cable Replacement

Callout Component Name

Preliminary Procedures

  1. Remove the radio. Refer to Radio ReplacementΒ .
  2. Remove the driver side knee bolster reinforcement. Refer to Driver Knee Bolster Reinforcement Replacement (Equinox) , Driver Knee Bolster Reinforcement Replacement (Terrain) .
  3. Remove the instrument panel compartment door. Refer to Instrument Panel Compartment Door Replacement (Terrain) , Instrument Panel Compartment Door Replacement (Equinox)
  4. Remove the windshield side garnish molding. Refer to Windshield Side Garnish Molding Replacement
1 Digital Video Antenna Cable

Procedure

  1. Disconnect all of the electrical connectors. Cable connects to the radio, communication interface module, and the navigation signal splitter.
  2. Note the cable routing prior to removal for installation purposes.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.