Circuit/System Verification

2013 Chevrolet Equinox LS, AWD, GasSECTION Circuit/System Verification
  1. Verify no DTCs are present.
    • If no DTCs are present.Β 
  2. Ignition ON, A11 radio ON.
  3. Verify that all radio controls operate and perform the correct function.
    • If some, but not all, controls operate normally.Β 

      Replace the A20 radio/HVAC controls.

    • If all controls are inoperative.Β 

      Refer to Circuit/System Testing below

    • If all radio controls operate and perform the correct function.Β 
  4. All OK.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.