Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2013EQUINOX LS, AWD, GASREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTCELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESNO GLOBAL POSITIONING SYSTEM (GPS) RECEPTIONCIRCUIT/SYSTEM VERIFICATION

2013 Chevrolet Equinox LS, AWD, Gas

Circuit/System Verification

2013 Chevrolet Equinox LS, AWD, GasSECTION Circuit/System Verification

NOTE:

The following verification requires the vehicle to be outside with an unobstructed view of the southern sky. Allow 5 minutes after turning the ignition ON for the vehicle to acquire the GPS satellites signal.

Ignition ON.
Verify that no DTCs are set.
- If any DTCs are set
  Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- If no DTCs are set
Verify that an OnStar advisor can locate the vehicle after performing a blue button press.
- If the advisor can not locate the vehicle and the vehicle is not equipped with a navigation radio
  Refer to Circuit System Testing Without Navigation Radio below.
- If the advisor can not locate the vehicle and the vehicle is equipped with a navigation radio
  Refer to Circuit System Testing With Navigation Radio below.
- If the advisor can locate the vehicle
Verify that the NO GPS symbol/message is not displayed on the radio.
- If the NO GPS symbol/message is displayed
  Refer to Circuit System Testing With Navigation Radio- Step 9 below.
- If the NO GPS symbol/message is not displayed
All OK.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.