Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBā LIVE
HOMESERVICE MANUALSCHEVROLET2013EQUINOX LS, AWD, GASREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTCELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESNAVIGATION SYSTEM - VOICE RECOGNITION MALFUNCTIONCIRCUIT/SYSTEM VERIFICATION
2013 Chevrolet Equinox LS, AWD, Gas
Circuit/System Verification
2013 Chevrolet Equinox LS, AWD, GasSECTION Circuit/System Verification
- Verify the OnStar Ā® voice recognition system is operating normally.
- If the OnStar Ā® voice recognition system is not operating normally.Ā
Refer to OnStar Voice Recognition MalfunctionĀ .
- If the OnStar Ā® voice recognition system is operating normally.Ā
- If the OnStar Ā® voice recognition system is not operating normally.Ā
- Ignition ON, radio ON.
- Begin voice recognition for the radio and clearly speak one of the available commands.
- Verify the infotainment system responds correctly to the command.
- If the infotainment system does not respond correctly to the command.Ā
- Clearly speak a different command.
- Verify the infotainment system responds correctly to the command.
- If the infotainment system does not respond correctly to any commands, refer to Circuit/System Testing below.
- If the infotainment system responds correctly to the command.
- Refer to the navigation system owners manual for hints on speaking commands.
- If the infotainment system responds correctly to the command.Ā
- All OK
NOTE:
Refer to the Navigation System Owners Manual for voice recognition use and commands.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- ā¢ You smell fuel, burning insulation, or see smoke.
- ā¢ Brakes feel soft, pull hard to one side, or make grinding noises.
- ā¢ The engine overheats, stalls repeatedly, or misfires under load.
- ā¢ You are missing required tools, torque specs, or safe lifting equipment.
- ā¢ You are not confident in the next step or safety outcome.