Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Verification
2013 Chevrolet Equinox LS, AWD, GasSECTION Circuit/System Verification
- With the vehicle outside in an area with an unobstructed view of the southern sky, tune to XM.
- Verify DTC B125C is not set as current and the No XM Signal message is not displayed on the radio.
- If DTC B125C is set as current or the No XM Signal message is displayed.
Refer to Circuit/System Testing below.
- If DTC B125C is not set as current and the No XM Signal message is not displayed.
- If DTC B125C is set as current or the No XM Signal message is displayed.
- All OK.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.