Remote Control Door Lock Receiver Replacement (With UFL)

2013 Chevrolet Equinox LS, AWD, GasSECTION Remote Control Door Lock Receiver Replacement (With UFL)
Fig 1: Remote Control Door Lock Receiver
GM2716398Courtesy of GENERAL MOTORS COMPANY
Remote Control Door Lock Receiver Replacement (With UFL)

Callout Component Name
Preliminary Procedure 
NOTE:

The Quarter Window Trim Finish Panel only needs to be repositioned to gain access to the Remote Control door Lock Receiver. The seat belt does not need to be removed from the panel.


Reposition the quarter window trim finish panel - left side. Refer to Quarter Window Trim Finish Panel Replacement .
1 Remote Control Door Lock Receiver

Procedure

  1. Disconnect the electrical connector.
  2. Unsnap the receiver from the bracket.
  3. For programming and set up, refer to Control Module References
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.