Windshield Wiper Transmission Replacement (Equinox)

2013 Chevrolet Equinox LS, AWD, GasSECTION Windshield Wiper Transmission Replacement (Equinox)
Fig 1: Windshield Wiper Transmission (Equinox)
GM2236191Courtesy of GENERAL MOTORS COMPANY
Windshield Wiper Transmission Replacement (Equinox)

Callout Component Name

Preliminary Procedures

  1. Remove the air inlet screen. Refer to Air Inlet Screen Replacement (Terrain) , Air Inlet Screen Replacement (Equinox) .
  2. Disconnect the electrical connector to the windshield wiper motor.
1 Windshield Wiper Motor Transmission Bolt (Qty: 3)
CAUTION:

Refer to Fastener Caution .


Tighten 
9 N.m (80 lb in)
2 Windshield Wiper Motor Transmission

Procedure

  1. Transfer the windshield wiper motor to the transmission assembly. Refer to Windshield Wiper Motor Replacement (Equinox Terrain) .
  2. Position the transmission assembly into the plenum upper panel.
  3. Secure the transmission to outer fender flange bolt first, followed with the other two transmission bolts.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.