SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013EQUINOX LS, AWD, GASREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTINTERIOR/EXTERIOR TRIMINSTRUMENT PANEL TRIM AND CONSOLE TRIMSPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2013 Chevrolet Equinox LS, AWD, Gas

Fastener Tightening Specifications

2013 Chevrolet Equinox LS, AWD, GasSECTION Fastener Tightening Specifications
Fastener Tightening Specifications

Application Specification
Metric English
Brake Pedal Bracket to the Instrument Panel Carrier Assembly 22 N.m 16 lb ft
Drivers Knee Bolster Panel Fasteners 2.5 N.m 22 lb in
Drivers Knee Bolster Panel Reinforcement Fasteners 9 N.m 80 lb in
Front Floor Console Accessory Trim Plate Fasteners 2.5 N.m 22 lb in
Front Floor Console Armrest Fasteners 2.5 N.m 22 lb in
Front Floor Console Bolts 9 N.m 80 lb in
Front Floor Console Compartment Door Latch Fasteners 2.5 N.m 22 lb in
Front Floor Console Nuts 9 N.m 80 lb in
HVAC Module to the Instrument Panel Carrier Assembly 6 N.m 53 lb in
Instrument Panel Carrier Assembly to the Mod Plate 22 N.m 16 lb ft
Instrument Panel Carrier Assembly to the Vehicle Body 22 N.m 16 lb ft
Instrument Panel Center Compartment Bracket Fasteners 2.5 N.m 22 lb in
Instrument Panel Center Compartment Fasteners 2.5 N.m 22 lb in
Instrument Panel Cluster Trim Plate Bezel Fasteners 2.5 N.m 22 lb in
Instrument Panel Compartment Door Dampener Fasteners 2.5 N.m 22 lb in
Instrument Panel Inflatable Restraint Fasteners 9 N.m 80 lb in
Instrument Panel Insulator Panel Fasteners 2.5 N.m 22 lb in
Instrument Panel Lower Extension Accessory Bezel Fasteners 2.5 N.m 22 lb in
Instrument Panel Lower Trim Pad Retainer Fasteners 2.5 N.m 22 lb in
Instrument Panel Upper Trim Panel Bolt 2.5 N.m 22 lb in
Instrument Panel Upper Trim Panel Screws 2.5 N.m 22 lb in
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.