SYS.OK|MANUAL.DB● LIVE
2013 Chevrolet Cruze LS, 1.8L Eng VIN H, Standard Trans

Quick Lookups: Fluids

2013 Chevrolet Cruze LS, 1.8L Eng VIN H, Standard TransSECTION Fluids
FLUID CAPACITIES
Fluid Type Application Standard Metric Fluid Spec Note S/H
Air Cond Compressor Oil 4.30 OZS. 0.12 L PAG 46 S
Air Cond Refrigerant 1.40 LBS. 0.63 KG R-134a S
Automatic Transmission Fluid 1.8L Eng Drain Plug N/A N/A Automatic Transmission Fluid DEXRON VI Fluid Capacity is between: 4.75 - 5.8 qts. S
Automatic Transmission Fluid 1.8L Eng Overhaul 8.05 QTS. 7.61 L Automatic Transmission Fluid DEXRON VI S
Automatic Transmission Fluid 1.8L Eng Valve Body Cover Removal N/A N/A Automatic Transmission Fluid DEXRON VI Fluid Capacity is between: 4.2 - 5.3 qts. S
Brake Fluid N/A N/A DOT 3 Hydraulic Brake Fluid S
Engine Coolant 1.8L Eng 5.92 QTS. 5.6 L 50/50 mixture of DEX-COOL and clean, drinkable water S
Engine Oil 1.8L Eng 4.75 QTS. 4.49 L API - SAE 5W-30 Use only engine oil licensed to the dexos1 specification, or equivalent, of the proper SAE viscosity grade. ACDelco dexos1 Synthetic Blend is recommended. If in an area of extreme cold, where the temperature falls below -20Deg.F (-29Deg.C), an SAE 0W-30 oil may be used. An oil of this viscosity grade will provide easier cold starting for the engine at extremely low temperatures. S
Manual Transmission Fluid Total Capacity 2.00 QTS. 1.89 L Manual Transmission Fluid GM Part No. 19259104. S
Windshield Washer Fluid 2.65 QTS. 2.5 L Windshield Washer Fluid Follow the Manufacturer's Instructions for the mixture ratio. Automotive windshield washer fluid that meets regional freeze protection requirements. S
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.