Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013CORVETTE BASE, 2D CONVERTIBLE, STANDARD TRANS, TRANS MFR CD 6L85M/MM6REPAIR AND DIAGNOSISELECTRICALINSTRUMENT PANEL SYSTEM DISPLAYS AND GAUGESDIAGNOSTIC INFORMATION AND PROCEDURESDTC P0463COMPONENT TESTING
2013 Chevrolet Corvette Base, 2D Convertible, Standard Trans, Trans Mfr CD 6L85M/MM6
Component Testing
2013 Chevrolet Corvette Base, 2D Convertible, Standard Trans, Trans Mfr CD 6L85M/MM6SECTION Component Testing
- Ignition OFF, remove the fuel level sender.
- Sweep the fuel level sensor through its full range of motion while measuring resistance between the signal terminal 1 and the low reference terminal 4.
- Test for a minimum resistance value of 37-43 Ω and a maximum value of 245-255 Ω without any spikes or dropouts.
- If minimum resistance is not 37-43 Ω, maximum resistance is not 245-255 Ω, or if there are any spikes or dropouts
Replace the fuel level sensor.
- If minimum resistance is 37-43 Ω, maximum resistance is 245-255 Ω, and if there are no spikes or dropouts
- If minimum resistance is not 37-43 Ω, maximum resistance is not 245-255 Ω, or if there are any spikes or dropouts
- All OK.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.