SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013CORVETTE BASE, 2D CONVERTIBLE, STANDARD TRANS, TRANS MFR CD 6L85M/MM6REPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALFUEL SYSTEMENGINE CONTROLS/FUEL - 6.2L, OR 7.0L - REPAIR INSTRUCTIONSREPAIR INSTRUCTIONSSUPERCHARGER BYPASS VALVE ACTUATOR REPLACEMENT
2013 Chevrolet Corvette Base, 2D Convertible, Standard Trans, Trans Mfr CD 6L85M/MM6

Supercharger Bypass Valve Actuator Replacement

2013 Chevrolet Corvette Base, 2D Convertible, Standard Trans, Trans Mfr CD 6L85M/MM6SECTION Supercharger Bypass Valve Actuator Replacement
Fig 1: View Of Supercharger Bypass Valve Actuator
GM2159710Courtesy of GENERAL MOTORS COMPANY
Supercharger Bypass Valve Actuator Replacement

Callout Component Name

Preliminary Procedure

  1. Remove the charge air bypass regulator solenoid. Refer to Charge Air Bypass Regulator Solenoid Valve Replacement 
  2. Remove the three power steering bracket bolts. Refer to Power Steering Pump Replacement (LS3, LS7) , Power Steering Pump Replacement (LS9)
1 Supercharger Air Bypass Regulator Actuator Fastener
CAUTION:

Refer to Fastener Caution .


Tighten 
10 N.m (89 lb in)
2 Supercharger Air Bypass Regulator Actuator

Procedure

  1. Disconnect the Vacuum Tube from the supercharger.
  2. Disconnect the vacuum tubes from the supercharger air bypass regulator actuator.
  3. Adjust the valve. Refer to Supercharger Assemble
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.