Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013CORVETTE BASE, 2D CONVERTIBLE, STANDARD TRANS, TRANS MFR CD 6L85M/MM6REPAIR AND DIAGNOSIS (SINGLE PAGE)DRIVELINES & AXLESDIFFERENTIALS & DRIVE AXLESREAR DRIVE AXLEREPAIR INSTRUCTIONSOUTPUT SHAFT SEAL REPLACEMENTREMOVAL PROCEDURE
2013 Chevrolet Corvette Base, 2D Convertible, Standard Trans, Trans Mfr CD 6L85M/MM6
Removal Procedure
2013 Chevrolet Corvette Base, 2D Convertible, Standard Trans, Trans Mfr CD 6L85M/MM6SECTION Removal Procedure
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the appropriate rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
- Remove the appropriate drive shaft. Refer to Rear Wheel Drive Shaft Replacement .
- Remove the differential output shaft seal.
IMPORTANT:
Take care not to damage any sealing surfaces when removing the differential output shaft seal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.