SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2013CORVETTE BASE, 2D CONVERTIBLE, STANDARD TRANS, TRANS MFR CD 6L85M/MM6REPAIR AND DIAGNOSIS (SINGLE PAGE)DRIVELINES & AXLESDIFFERENTIALS & DRIVE AXLESREAR DRIVE AXLEREPAIR INSTRUCTIONSDIFFERENTIAL OIL PUMP INLET HOSE REPLACEMENTREMOVAL PROCEDURE
2013 Chevrolet Corvette Base, 2D Convertible, Standard Trans, Trans Mfr CD 6L85M/MM6

Removal Procedure

2013 Chevrolet Corvette Base, 2D Convertible, Standard Trans, Trans Mfr CD 6L85M/MM6SECTION Removal Procedure
    Fig 1: Identifying Differential Cooler Inlet Pipe
    GM1503806Courtesy of GENERAL MOTORS COMPANY
  1. Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE .
  2. Lower and support the rear of the exhaust system.
  3. Install a drain pan under the vehicle.
  4. Remove the differential cooler pump inlet pipe retaining bolt.
  5. Disconnect the differential cooler pump inlet pipe from the differential. Refer to Differential Cooler Hose/Pipe Quick Connect Fitting .
  6. Disconnect the differential cooler pump inlet pipe from the differential cooler pump. Refer to Differential Cooler Hose/Pipe Quick Connect Fitting .
  7. Remove the differential cooler inlet pipe from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.