Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2013CAMARO ZL1, 2D COUPE, AUTOMATIC TRANSREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTCELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEMREPAIR INSTRUCTIONSMULTIMEDIA PLAYER INTERFACE MODULE REPLACEMENT

2013 Chevrolet Camaro ZL1, 2D Coupe, Automatic Trans

Multimedia Player Interface Module Replacement

2013 Chevrolet Camaro ZL1, 2D Coupe, Automatic TransSECTION Multimedia Player Interface Module Replacement

Fig 1: Multimedia Player Interface Module, Front Floor Console Upper Trim And Bolts

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the front floor console. Refer to Front Floor Console Replacement . Remove the front floor console armrest. Refer to Front Floor Console Armrest Replacement . Remove the console compartment power receptacle. Refer to Accessory Power Receptacle Replacement . Remove the USB receptacle. Refer to Audio Disc Player and USB Receptacle Replacement .
1	Front Floor Console Bolts (Qty: 4) CAUTION: Refer to Fastener Caution . Tighten 2.5Y (22 lb in)
2	Front Floor Console Upper Trim
3	Multimedia Player Interface Module Procedure Slide the module upwards after disengaging retaining clips. Disconnect the electrical connectors.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.