Service Indicator Always On

Service Indicator Always On

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.

* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

Circuit/System Description

If the service indicator needs to be turned on the transfer case shift control module sends a signal via LAN to the instrument panel asking the I/P to command the Service 4WD indicator.

Reference Information

Schematic Reference

Transfer Case Control Schematics MP 3023/3024-NQH - Transfer Case

Connector End View Reference

Component Connector End Views Connector End Views By Name

Electrical Information Reference

* Circuit Testing Circuit Testing

* Connector Repairs Connector Repairs

* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections

* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Control Module References for scan tool information.

Circuit/System Testing

1. If the Service 4WD indicator is on and there are no DTCs check the fuse for the transfer case as this would cause the transfer case control module to drop off the LAN causing a service indicator.

2. If the fuse is good check the module power and grounds for proper connections as this could cause the same thing as a blown fuse.

3. If this checks OK then check all other U codes that may be set against the transfer case shift control module such as I/P, BCM, PCM, and follow the proper U code diagnostic.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

* Control Module References Control Module References for TCSCM replacement, setup, and programming

* Transfer Case High/Low Clutch Reset Transfer Case High/Low Clutch Reset