SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012CHEVY EXPRESS G2500, VAN PASSENGER, 4.8L ENG VIN AREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2466 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEW 5 OF 5)STEERING ANGLE SENSOR
2012 Chevrolet Chevy Express G2500, Van Passenger, 4.8L Eng VIN A

Steering Angle Sensor

2012 Chevrolet Chevy Express G2500, Van Passenger, 4.8L Eng VIN ASECTION Steering Angle Sensor
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Steering Angle Sensor Connector End View
GM280793Courtesy of GENERAL MOTORS CORP.
Steering Angle Sensor

Pin Wire Color Circuit Function
1 0.35 GY 6044 5-Volt Reference
2 0.35 OG/BK 6045 Low Reference
3 0.35 YE 6046 Steering Angle Sensor Phase A
4 0.35 D-BU 6047 Steering Angle Sensor Phase B
5 0.35 TN 6048 Steering Angle Sensor Phase C
6 0.35 L-GN 6043 Steering Angle Sensor Signal
7-8 - - Not Used
Connector Part Information 
  • OEM: 12052444
  • Service: 12101874
  • Description: 8-Way F Micro-Pack 100 Series (BK)
Terminal Part Information 
  • Terminal/Tray: See Terminal Repair Kit
  • Core/Insulation Crimp: See Terminal Repair Kit
  • Release Tool/Test Probe: See Terminal Repair Kit
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.