Glow Plug Control Module Replacement

2012 Chevrolet Chevy Express G2500, Van Passenger, 4.8L Eng VIN ASECTION Glow Plug Control Module Replacement
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 GMC Savana Special, 2010 GMC Savana Camper Special, 2010 GMC Savana, 2010 Chevrolet RV Cutaway, and 2010 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Glow Plug Control Module
GM2375211Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Remove the engine cover. Refer to Engine Cover Replacement .
1 Glow Plug Module Fastener (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
10 N.m (89 lb in)
2 Glow Plug Module

Procedure

  1. Disconnect the electrical connectors.
  2. For setup and programming, refer to Control Module References .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.