Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012CHEVY EXPRESS G2500, VAN PASSENGER, 4.8L ENG VIN AREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1374 (ENGINE CONTROLS AND FUEL - 4.8L, 5.3L, 6.0L, 6.2L - DTC P0230 TO DTC P0690)DTC P0443 OR P0449CIRCUIT/SYSTEM TESTING
2012 Chevrolet Chevy Express G2500, Van Passenger, 4.8L Eng VIN A
Circuit/System Testing
2012 Chevrolet Chevy Express G2500, Van Passenger, 4.8L Eng VIN ASECTION Circuit/System Testing
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the EVAP canister purge or vent solenoid valve.
- Ignition ON, verify that a test lamp illuminates between the voltage supply circuit terminal A and ground.
- If the test lamp does not illuminate, test the voltage supply circuit for a short to ground or an open/high resistance. If the circuit tests normal and the voltage supply circuit fuse is open, test or replace the EVAP canister purge solenoid.
- Connect a test lamp between the voltage supply circuit terminal A and the control circuit terminal B.
- Command the EVAP canister purge solenoid valve to 50 percent with a scan tool, or the EVAP canister vent solenoid valve ON and OFF. The test lamp should respond to the command.
- If the test lamp is always ON, test the control circuit for a short to ground. If the circuit tests normal, replace the ECM.
- If the test lamp is always OFF, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the ECM.
- If all circuits test normal, replace the appropriate solenoid valve.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.