Typical Scan Tool Data

2012 Chevrolet Chevy Express G2500, Van Passenger, 4.8L Eng VIN ASECTION Typical Scan Tool Data
WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
EC Ignition Relay

Display Parameters Normal Range Short to Ground Open/High Resistance Short to Voltage
Operating Conditions:Β  Ignition ON, engine OFF, powertrain relay commanded ON.
EC Ignition Powertrain Relay Circuit Status OK/Incomplete Short to GRD/Open Short to GRD/Open Short to B+
EC Ignition Powertrain Relay Command ON ON ON ON
EC Ignition Powertrain Relay Feedback Signal 12-12.9 V 0.0 V 0.0 V 12-12.9 V
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.