Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012CHEVY EXPRESS G2500, VAN PASSENGER, 4.8L ENG VIN AREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1251 (ENGINE CONTROL SYSTEM & FUEL - HYBRID (HP2) 6.0L (LFA) - DTC P0231 TO DTC P0690)DTC P0351-P0358CIRCUIT/SYSTEM VERIFICATION
2012 Chevrolet Chevy Express G2500, Van Passenger, 4.8L Eng VIN A
Circuit/System Verification
2012 Chevrolet Chevy Express G2500, Van Passenger, 4.8L Eng VIN ASECTION Circuit/System Verification
WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, open the hood to disable the Auto-Stop function. Refer to Hybrid Modes of Operation Description .
- Ignition ON, verify the scan tool hood position parameter displays Open.
- If the hood position does not display Open, refer to Diagnostic Trouble Code (DTC) List - Vehicle for DTC P254F.
- Engine running, monitor the following ignition control (IC) circuit status parameters with a scan tool.
- Cylinder 1-8 Ckt. Short Gnd Test Status
- Cylinder 1-8 Ckt. Open Test Status
- Cylinder 1-8 Ckt. Short to Volts Test Status
Each parameter should display OK.
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.