SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012CHEVY EXPRESS G2500, VAN PASSENGER, 4.8L ENG VIN AREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1202 (KEYLESS ENTRY SYSTEM & REMOTE FUNCTIONS)REPAIR INSTRUCTIONSREMOTE CONTROL DOOR LOCK RECEIVER REPLACEMENT (EXCEPT AVALANCHE/ESCALADE EXT)
2012 Chevrolet Chevy Express G2500, Van Passenger, 4.8L Eng VIN A

Remote Control Door Lock Receiver Replacement (Except Avalanche/Escalade EXT)

2012 Chevrolet Chevy Express G2500, Van Passenger, 4.8L Eng VIN ASECTION Remote Control Door Lock Receiver Replacement (Except Avalanche/Escalade EXT)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Remote Control Door Lock Receiver (Except Avalanche/Escalade EXT)
GM1808081Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure: 
Remove the back rear corner upper garnish molding. Refer to Body Rear Corner Garnish Molding Replacement - Left Side (w/E61) or Body Rear Corner Garnish Molding Replacement - Left Side (w/o E61) .
1 Remote Control Start Antenna Assembly
Tip:  Disconnect the electrical connector.
2 Remote Control Door Lock Receiver
Tip: 
  • The module slides and snaps into the body structure.
  • Disconnect the electrical connector.
  • If a replacement module is installed, program the module. Refer to Control Module References .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.